Posted by pkurilecz on November 28, 2010 at 15:08:17 from (68.88.199.97):
In Reply to: Re: Accident question posted by Paul N Texas on November 28, 2010 at 12:07:33:
My understanding is that in TX, a farmer who is moving a piece of equipment from one farm location to another farm location is exempt from obtaining high/wide load permits.
If the equipment is wide, you are required to yield to it just as one is required to yield to a permitted wide load.
That being said, trying to cross a bridge where the equipment takes up the whole width without holding opposing traffic until the equipment crosses does seem to be a very poor and unwise decision.
All I can say is that when I transport equipment from one location to the other, I am so glad to be off the road.
When I move wide equipment, I get my neighbors to help me, especially on the narrow bridges.
All in all a very bad situation and I am so glad not to be in their shoes.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.