I was going to explain to you just what Owen did but could not have done it any better. when you said it only leaked down till it got to 2500 that was the clue needed. If you would place the gage in the upper end of the cylinder it would demonstrate that the pressure is equalizing across the cylinder and for all practical purposes you have a system that is being held up by a effective piston the size of the cylinder rod. If you warm the oil in the system then hold the system against relief anf feel the inlet fittings on the cylinders the one leaking through should get hot while the good one will stay cool, You could double check by lifting the loader up , allowing it to settle till it stops and then with the engine shut off pull the lever to the raise position and it should go down as you have opened a return on the rod end of the cylinder to sump. I believe you said it was the lift circuit so I assume two cylinders. Your senses are your best tool when diagnosing hydraulics, I have worked since 62 using methods such as this. mEl
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
