Posted by sonny2 on December 28, 2010 at 18:13:22 from (69.72.88.144):
In Reply to: 3/8 Lockwasher posted by Bill Copeland on December 28, 2010 at 09:12:59:
I was out on a mountain road one afternoon with my Model A coupe and I shut the engine off to go exploring, when I got in to start it the starter wouldn"t engage. So, I got out the crank and started it that way, when I got home I took the starter out. Here the bolt that held the bendix spring fell out. I got a magnet and tried to fish for the bolt. I didn"t get out and since there didn"t seem to be a problem, I juist put another bolt in. I drove it that way and later I had an accident where I rolled the car over. I didn"t think about the bolt until I tried to start the engine much later. It wouldn"t turn so I tried turning it in the opposite direction and I heard a clunk, duh, then the lightbulb lit up, that was the bolt. It jammedd the flywheel when the car rolled over. I never tried to get it out, because it didn"t matter. So I don"t think it would matter in a tractor. Paul
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
