if i had to do it all over again , 1975 i would had got a pup tent and camped out at Ford Motor Co Louisville, till they finally found a job for me ,Life would had been better and easir , But by then FORD was not hiring except from families who came to retirement parties ..,, as it Was ,since a wild tornado of 74' tore thru these parts ,, And repairs Were NEEDED badly, Built me some sawhorses and ladde rRacks , borrowed DADs Ladders , and started doing Home Improvement ,all the While farming and feeding Hoggs at nite , had Early success, Good help , And paid GOOD wages , Had some years where I grossed over $300K, Bought land during the 80s , The Smartest Thing I did !!!, Still Own 209 ac.,and the Farm provides a fair living ... early 1990s,, Burning the candle on both ends caught upwith me ,,,vertigo problem ?., had serveral Accidents and injuries , at the same time Something Criminal(Vertical integration ) in the Hog industry Pushed Me Out .... Went thru haleof divorce that nearly kiltMe ... And i Have survived.. thanx to cattle ,grain & timber sales ...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.