It was pretty common to work on our old discs, so you get used to it - we never replaced bearings unless they were really out or very rough...
At the most, you could move the new(est) bearing to the hardest to get to location and reuse the used bearing on the outside where its easy to get to in case it later goes out.
The biggest tip I learned - was be SURE not to crush the bearing hangers inward by tightening up the hangers on the main beam and THEN tightening the gang bolt!!
In other words, leave the bearing hangers loose on the main beam - then tighten the main gang bolt holding the discs as tight as you can get it (I made a special 8 feet long box end wrench for really torquing down my big 45 foot Krause disc plow gangs).
After the discs are "singing" tight - then tap the hangers back and forth a little on the beam to "center them" in their natural position hanging and then tighten them on the frame. That takes any sideways stress off the bearings as much as possible.
I've seen a disc thrash the bearings in one round before where the guys didn't do that...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.