I have rebladed more I H disc's then i want to think about over the years , as i use to buy them with woren blades and fix them up for resale . It is all bull work ya need a good torch a big chain wrench or at least a 36 in pipe wrench a ten pound sledge a 1 inch drive air wrench and sockets are a huge plus but a good 3/4 drive and long pipe will work. and and extra set of hands is also a plus . I would drop the whole gang after i had the arbor nut off and go at it and lay everything out as it came off. Then i would masseur the blades and save anything over 18 inches and scrap the rest and save them for another one that only needed a few . I would put new 20 inch 7 gauge blades along with any bearings that were even iffy add a paint job and ship . did usually 5-7 a year . Oh and when ya think you have the big nut tight enough hit the other end of the arbor with the sledge and tighten some more each good hit will give about a quarter more of a turn till she is tight . Sometimes they will come apart easy and then there are times they will not .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.