Posted by D Slater on February 02, 2011 at 16:23:55 from (184.15.13.104):
In Reply to: Filling silos posted by charlie M on February 02, 2011 at 11:34:02:
In my younger days a belt driven JD blower was used. Silo was concrete with steel rods around it. Can't remember the height but think it was more than 40 feet. Had a roof cone also. The blower loading bed with a auger was made to back a wagon or truck up to. Used head boards hooked to two winch cables to pull load out the back. When unloaded the boards were drug back to the front by hand. Family used to plant corn to outside edge of the fields. Before cutting field, a strip was cut near center of field by hand and layed to the side. Then fed into the silage cutter by hand to keep from wasting any corn before starting on the standing corn. Was a dairy farm, I didn't get away from the farm long enough to know there was better ways of doing things, until uncle sam decided I should do something else for a while. Also used JD cutters. Had 2 with there own power engine. One had a V4 wisconsin, other a 4 cylinder continental. Last one was used the most. Both were crank start, if the wisconsin died or had to be shut off in use. It was pretty much a no start until it cooled down. Tractors used, farmall H, ferguson 40 and a ford. Silage equipment was the only JD stuff on the farm.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.