Posted by Fred Martin on February 12, 2011 at 05:41:00 from (216.158.74.104):
In Reply to: Metric Size Nuts posted by Dave Sherburne NY on February 11, 2011 at 10:37:19:
Take a flat piece of lead and lay it on the threads and tap it with a hammer and it will imprint the threads per inch or millimeter. Take a piece of number 9 wire and bend in a loop/u shape and bend till it just touches the outside diameter of the male threads with no clearance or gap and head for an automotive machine shop or such. They can tell you what thread it is. I have made nuts in this way that fit like a charm...without seeing the threaded shaft. And the good part of this is the machinist that fits you up will look over at his coworkers when you leave and say "There is a smart man!" ohfred
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
