I know you are a better welder than I am, so maybe you can give me some advice here.
First up, I have an Esab 260 Multimaster (wire feed 70 R3 wire, and DC stick up to 300 amps, plus torches).
Because of serious risk of somebody getting hurt or maimed if a load falls when a fork breaks, I will not be welding the broken ones. I bought nearly new ones 2" thick X 6" wide at the top of the fork X 48". They look to be in excellent shape, and still have the manufacturer's stickers on them. But the fork carrier frame I have needs a loop at the top of the fork (these have the very stout hook that rides on a vertical flat, notched fork carrier. The rod holding the forks on my carrier is 1.75" diam, and never bent. The loops on the old forks are 1/2" wall thickness hollow tubing welded to the top edge of the fork.
So my plan is to get some round tubing with 1/2" wall thickness with a 2" diam bore, and weld them to the tops of each fork, with no need to eliminate the stout welded hook that is just below the top edge. The oversize bore is to allow some ease of fork movement on its support rod and make the possible weld distortion and shrinkage of the welded tube a non critical issue. I have not bought this steel yet.
The welding plan: 1) Clean all oil residue from the top area of the fork. 2) preheat the weld area with a big propane torch. 3) Lay a root weld with 6011 DC. 4) Layer up with 7018 DC.
As the shielded wire (.035) is faster to use, I would prefer to use that, but am concerned with not enough penetration. What's your thoughts about wire VS rod, and any recommendations about welding proceedure? I hope to do this within the next week.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.