Posted by INCase on February 17, 2011 at 11:50:20 from (209.221.240.193):
In Reply to: Re: ACG, CASE 400 ? posted by JayinNY on February 17, 2011 at 04:30:23:
presume you're talking about the big 400s. as Harry mentioned its set up like the 770/880 olies with 2 sets in one shifter. 1-4 in the 'rearward" position 5-8 forward. the gears are "backwards" from most standard shift patterns though. 1st/5th is in the lower right spot. 4th/8th is in the upper left and reverse is far left back( towards you) I've found the to be a bit much to get in between ranges (probably worn out) so I switched my from a 61 730 parts tractor to a dual shifter set up. some like the 2 stick some like 1.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.