Many years ago Dad had a three point carrier that was a little different from any I've seen since. Instead of having the two lower pins fixed on the frame, the frame had some loops. A regular drawbar, like the kind you see used between the lower arms, slide through the loops. The loops allowed for the bar to have about 4" of travel up and down, and the uprights limited the side to side travel to about an inch or so, so that it was very easy to hitch up. The 4" or so of "float" meant that it would always go down to the ground. Maybe someone here has a photo of one. I would buy another one like it in a minute, it really worked well. The standard dimensions for category I and II are posted somewhere on this website. One thing you might want to consider is to make your stuff compatible with quick hitches. I use a JD i-Match on my small tractor. Deere has been building their stuff so it is compatible with their quick hitches for years. A lot of other stuff, even though it might have the right dimensions for Category I, won't work because something is in the way of the quick hitch coming in from under and raising up to engage. Usually the top link hitch point is the problem. The ears for the top hitch are often welded on top - like you have done on your receiver hitches, so that the quick hitch hook can't get under it. Making your stuff quick hitch compatible would give you a leg up on most of your competition.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.