He is very fortunate, someone was watching over him. I could not imagine the feeling knowing what is about to happen.
I think it is absolutely necessary to walk and or familiarize ones self with the work area, especially if new to it, always pays off when you find these things and mark them conspicuously. Even then, sometimes you may not find every hazard.
We have a 115,000 volt circuit and a 30,000 volt circuit coming through here, the 30,000 one has double wood poles, x braced at the end of a run before it connects to a large tower, passing over water and a state road, 2 guys on each side, 4 in all, they are covered in a yellow plastic, shield, near the bottom, you can't miss em. One set is right in an old tractor path that I use, I have to go between em, always pay attention down there, you pull one of those poles over, there is 3 lines on each, 6 total, each w/30,000 volts. Power company has to provide places to pass, when they bisect your land, nothing I could do about the location of the guys, their land.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
