I wondered about that myself, and tried foam once unsuccessfully. Sounds like a good deal, except possibly the cement portions that touch the outside and then transfer cold in, or heat out. Years ago I finished a cinder block basement for my mother, and insulated the walls with the blue styrofoam sheets, and then studded my walls inside of them so no wood wood make contact with the cinder blocks, then finsihed the walls with ventilation at the top and bottom. Also put in a ventless gas heater down there. It didn't take much to get toasty in the winter, and the summer retained coolness that settled from upstairs. Just a thought.
Here's something not to try, trying to foam the walls like I tried. That 3M foam great stuff? I did try to insulate the inside of cinder blocks with that. Bad idea, at least the way I did it. If you put the nozzle on the can, and have several cans to empty, takes a long time, and wears the fingers out. Then I broke one of those nozzles off but had a whole can and found that I could empty the whole can in about 3 seconds without a nozzle. Great idea, so I thought. Went through about 6 or 8 cans or so, emptying in seconds until the last can. There was a huge flash, I was engulfed in a blue flame along with the wall. It went out in seconds, singed the hair off of my arms and face, and kept smelling like it was burning, but thankfully went out. I did NOT get hurt, luckily. The cans say that they can "flash fire" and they are not joking. I told a fireman friend of mine about it afterwards, and posted here about it, and a tractor owner fireman here expained it as well, although I don't recall the exacts about the chemicals mixing with air too fast, BUT DO NOT MAKE MY SAME MISTAKE. You could get killed or burn the place down doing that, or both. I figure I got lucky.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
