in-too-deep, if you want to try it, get 2 identical metal coat hangars, cut the bottom off one side, then the other side at the bend go up 5 inches and cut the hangar. bend it so you have a 90 degree angle and the short end sticking up about 5 inches. do the same for the other hanger. make a loose fist, set the hanger 5 inch side into the fist and let the end sit on the side of you little finger so it swings freely. hold the other one the same way. hold your hands about 8 to 10 inches apart chest high and walk slowly ahead. the hangars should be parallell to each other. when you cross over something, ie field tile, waterline ect, they will pull together quickly, or spread wide apart. drop a marker at this spot, move over about 10 feet and repeat. this is the way i mark field tiles. supposedly it works because the dug line causes a magnetic field the wires pick up. moving water underground causes the same thing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
