Forgot to mention, a stuck or bent valve, or something along that line would have also been indicated by the compression test I did. Instead all 4 cylinders tested good which told me none of the valves were stuck or bent in an open position where the piston would hit them and cause a knock, nor had the injectors squirting fuel directly on top of the pistons caused them to get a hole burned in them as commonly happens with bad injectors that squirt like these did. The strange thing about this whole deal is that #4, which is the one that ventilated the block, tested about 15 psi better than the lowest one and 5 psi better than the next in line. With a rod that has spun enough to be sloppy and create a knock like we were hearing it should have sounded like it was on the bottom end for one, but also, you'd expect that cylinder to have a little lower compression than the others. In other words the crank wouldn't be pushing it quite as far up as the other pistons due to the lost bearing material in the top half of the bearing, therefore compression would be lower. In this case it was actually higher, go figure. Now if #2 had let go I wouldn't have been quite as suprised since it had the lowest compression of the bunch at just under 300. In the end all you can do is locate the apparent problems that would cause the symptoms your seeing, repair them, and go from there.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
