Farmall & IHC Tractors Discussion Board |
M Sleeve Will Not Budge
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John on July 13, 2001 at 16:15:38 from (165.121.50.90):
Need some help... I have a M Farmall with thin wall 4 inch piston sleeves. I am wanting to replace the worn sleeves with new 4 inch sleeves. I made a puller to remove the sleeves by taking a 4 and 1/8 inch disk and brazing an old piston ring to the top. The ring will fit into the bore and center the disk under the bottom of the sleeve. The edge of the disk sticks out approximately 1/16 inch all the way around to contact the bottom of the sleeve. I have used a 5/8 inch threaded rod through the center of the disk to make a puller. I have put considerable pressure on the sleeve with the puller, but it will not move a peg. Through the side inspection plate, I can see a good bit of rust on the outside of the sleeves. Any ideas on how to get the old sleeves to move? Thanks in advance John
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|