big let down for me too, how many times has some one cut wheat and the crop wasn't fire ready? I mean wow its too hot and dry to cut wheat!!! and the truck that overheated as well as the combine and you just walk away for an hour and see's fine??? I actually watch gauges and make sure its not getting up into melt down range, if it gets to high I remove the load and let her run at high idle to let her cool not wait until the system shuts it down then just say,,well we will have to blow that out tomorow!! also how amazing was it that the kid didn't know the wheat was green!!! what the monitors didn't tell him squat?( had to be throughing a lot over at least) heck even my 40 year old plus machines will tell you that, if back when I had customcutters work for me one had been "hogging" through a green field with no reguard for my bottom line they would have been out of there right now!then to magicly catch the field on fire then continue running the machine, one question, why did the fire go out on the machine?? and how dumb is he to get out and think he is going to stop a grain field fire of that size wita 20lb fire exteigisher?? REALLY???, sorry to rant but they are trying to tell "city" folk how this is done?? this is wrong from many angles
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
