Posted by jackinok on January 05, 2012 at 07:48:01 from (162.58.82.136):
update on the young lady that shot the intruder,,she is 18,her husband before he died was 58.She had lived on his place since she was fifteen and they were just recently married.She raises,or did raise, germans shephard puppies and sells them for a living. All her female dogs kept outside recently died under unusual circumstances (suspects they were poisoned). Fellow who was shot was high on perscription meds and was trying to get in the house because he thought husband might have painkillers there since he died of cancer. He had came to the house before,but she had company at the time and he left. Accomplice who ran to town to turn himself in said they been planning it for a long time and she had complained to her mother about someone watching her. When he showed up this time and started pounding on door she shoved the couch in front of door and called law. They dispatched a sheriff deputy,and she stayed on phone with dispatcher. She told dispatcher she had two guns,in her hand and asked if she should shoot if he came in. Dispatcher said she couldnt tell her to do that,but to do what she needed to do to protect her baby. Shot the guy with a 12ga and he died still holding a knife,draped over her couch.She has been exonerated of all charges ,but accompice has been charged with murder. Couch has been replaced,by caring neighbors and a account has been set up to help her out.(I'm personally donating a couple of boxes of 00 buck!)by the way,when reporter showed up at the house to get the story,she met them at the door with her dead husbands shotgun in hand!Like I've said before ,folks around here tend to be just a little independent!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
