You kind of have to feel your way through it don't you ? Hard to say being on the motor how much heat you can use if much at all to break any potentially seized bolts, if its just studs, as long as the threads are ok, can be chased, those just stay in place. The bolts if the heads are severely pitted, you know its bonded to the threads in the head or block, penetrating oil will mostly run off, now if'n you can turn the tractor on its side LOL !
I hate pondering this situation when you know you could deform the hex heads, easily snap one, only thing I learned with this is to take your time on each one, soon as you feel its going to round off, or really hard to turn, have to stop. Biggest thing I've found is to work both directions once it moves, little at a time.
I know what you fear, resorting to extractors, (hate those but they work when real careful or you had best stop before you snap one in place) welding a nut to the broken stud, without welding it to the block, counterclockwise drill bits, drilling out the center or even blowing out the center with a properly fitted cutting torch, me thinks its too much heat to try, so none of the above please LOL !!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
