Posted by Curious1 on January 29, 2014 at 22:01:51 from (99.23.5.65):
I have a potentially stupid question, so please be patient with me. I've been reading about the dangers of starting a tractor by hand with a crank. In one of the discussions, someone mentioned that the old John Deere tractors were safer because you turned the flywheel on the side of the tractor instead of a crank on the front. This got me wondering if it would be possible to replace the standard crank with a wheel that would slide onto the same shaft the crank fits on. You could then spin the wheel just like the John Deere flywheel. With a balanced wheel instead of a crank, it seems like there would be less danger of injury if the engine backfired. Once started, you could take the wheel of just like the crank. I'm sure somebody would have done this already if it would work, so can someone tell me why it won't? Thanks in advance.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
