Posted by rrlund on May 17, 2014 at 15:36:10 from (162.250.26.144):
In Reply to: Snap Rings posted by UP Oliver on May 17, 2014 at 12:37:54:
Why not just soak it in gas then blow the crud out with compressed air?
If you're bent on getting it out,I think I've had one out once,and that was by mistake the first time I took one apart. You'll need three screwdrivers just the right size and somebody to help you. Get two of them straight down in to it. One against one end of the ring,the other has to go against it so that they form a V with that one against the other end of the ring. Now twist so that one of them pushes one end of the ring out. Now have somebody else stick a thin one in the little bit of gap. Before it slips out,get an o-ring pick in there and turn it so the hook sticks out toward the center of the gear to keep it from slipping back in. Work a screwdriver around it now and work it up and out. It's more trouble than it's worth.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
