Posted by UP Oliver on May 17, 2014 at 18:44:54 from (68.70.134.87):
In Reply to: Re: Snap Rings posted by rrlund on May 17, 2014 at 15:36:10:
I though about doing the gas method, especially since the thing slides around so much in there. On a good note, I did get a couple of them out of the PTO unit as I am replacing the quad rings in there. I had to keep my eye on them, they flew out pretty far.
I know you have some Olivers, maybe you can tell me what else I should replace while I am in there? I had a hydraulic leak down into my gear compartment. Once I blocked off the hydraulic line to the PTO my hydraulic level stayed where it should be in the tank, so that is how I figured out my problem; or at least one of them. Would you have any advice on that?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
