Posted by Bobl1958 on June 20, 2014 at 08:56:57 from (68.98.205.31):
I am pretty sure I remember that you are running the Gehl balers. I have a 1875 with the Gehl monitor that sets the bale size and the wraps, etc. My question is, if you happen to have the same setup, is that the size of the bale on the monitor is not working. It is the bar graph that starts at 0 and climbs up as the bale gets bigger. And since it is not working, it won't alert me when the bale size is complete and start the tying phase. I have to manually push the button to tie. It will then tie the bale automatically and go back to "ready to bale mode" and then to start the procedure again. Last year when I blew everything off and put it in the shed everything was working fine. Just curious if you would have any ideas where to start. The book doesn't give any good info regarding the bale size. I can set the size of the bale with the monitor, just the size as it is building is not working. I can try to get some pics if you needed, but if you have the same setup (even though you have a smaller baler I seem to remember) I am hoping you might know something. It's probably in the Electronics somewhere, but I don't see anything that would look out of the ordinary. Thanks in advance - Bob
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
