Posted by Cas on March 04, 2015 at 13:03:03 from (67.240.155.24):
There is a post below about rings. Last few years, I have talked to a few cracker jack engine guys. Some of them can measure to the 0.0001. If the guy has a gas(not diesel) engine they are putting in over size rings in and grinding off enough material for a good ring gap. Naturally the ridge in top of the block is taken off. Also, the piston can not have so much wear that it will slap. Cylinders are ball honed with a coarse grit ball hone(can not remember the grit), This would be for engines where not a lot of hours are put on the machine. I did this once on my old Case 530 backhoe. It was about 4 years ago and the engine has a little over 450 hours on it now and no problems. Would any of you guys do this on a lower value machine? Forgot, put bearings in it they are cheap and I ground the valves,knurled the guides, used Chevy umbrella valve seals, and lapped the valves.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
