Posted by shunkfarm on May 11, 2015 at 06:54:11 from (216.255.37.201):
My nephew was given a 24' x 24' pole building. We have it most of the way down. I started wiggling one of the posts to see how well it was stuck in the ground and it snapped off. Very rotten. We went around and they all snapped off. The owner said the building is twelve years old.
When I was still building, treated was heavy, wet and very green. I have pulled posts that have been in the ground for years with no apparent deterioration. Is the modern treated that different or are there different grades of treated? I remember reading that the chemicals have been changed but this is unacceptable
Kid is planning on putting it back up but doubling the size and using new siding on the front and the reclaimed on the sides and rear. We want something in the ground that will last.
Does anybody have knowledge on contemporary treated or replacement materials and/or methods?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
