Posted by Billy NY on June 08, 2016 at 10:39:44 from (104.228.35.235):
In Reply to: Stuck motor posted by 37Chief on June 08, 2016 at 10:24:53:
I'm not so sure pulling is a good idea, given the potential for engine damage.
We had an IH 460 way back when, dear ole dad let it sit too long, that and with an exhaust leak under the hood, which must have let moisture in given what I recalled and where it was leaking. They tried to pull it in gear, good thing was it would not budge. This had a rebuilt motor, so the tolerances were not like a worn one.
One of my D7's is stuck, stack was covered, but when I retrieved it from the guy who borrowed it in the late 70's, it had sat a long time when I hauled it out in '03 or so. I was not able to get penetrant in the injectors, but was able to get some through the exhaust ports, don't think it did any good. I machined up a thick rod with a cross piece through it, and fit that to the big nut on the crankshaft on the front of the engine. We tried with a long pipe to turn it over, just tightened the nut slightly is all we did. The heads will have to come off, and I never liked the idea of not doing that, given the damage that can be done to the bore or liners in this case.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
