Posted by farmallsuperc53 on October 21, 2016 at 15:23:32 from (74.74.132.26):
I recently put back together my 1949 Farmall H after getting it unseized. I tried starting it for the first time today and was not able to get it to fire. All cylinders are getting spark and it has brand-new points and condenser along with the distributor cap and all of the wires. The firing order is correct and it has not fired one single time since trying to start it. The fuel mixture is right on the carburetor so I am assuming it Is the timing. It has a vertical distributor and is still 6v. I located the two notches in the camshaft pulley to find tdc (yes im sure it wasn't the oiler notch) I used the first notch that lined up with the timing pointer and then checked to see where the rotor was. I took off the cap and it was pointing (if looking down at the distributor from above facing the exhaust stack) to the bottom right(or farthest away from the engine and closest to the radiator. But the number one on my cap was one post over to the left. So I switched 1 plug to the terminal that the rotor was at on tdc and did firing order from there. Then moved distributor to find spark. But still when I go to start it it doesn't Fire once (and im sure it's on compression strike, I've tried both ways and even tried using the 2nd of the 2 notches on the camshaft pulley as tdc and same result. Any suggestions?[/i]
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.