When you turned the distributor to set the spark, did you turn the housing opposite the direction the rotor turns? That makes the points open on the leading side of the cam, as it will when running.
You say it was stuck before you started working on it... Are all the valves closing, no bent push rods? A simple test is to crank it with your hand over the carb inlet. It should make a strong, steady vacuum with no blow back.
And since it was stuck, you probably put oil in the cylinders to get it free. Possibly the plugs are splashed with oil, might take them out and clean them.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.