Posted by Leroy on June 24, 2017 at 06:56:22 from (69.88.204.212):
In Reply to: Re: RK LED shop light posted by SweetFeet on June 24, 2017 at 04:37:52:
I want the daylight version of all lights, to me it is easier on the eyes. I acidently got a hold of a couple of the warm light (yellow light) bulbs and they do not provide as much light. Just put 2 side by side and at night you can see the difference. I an now just vhanging over from the cfl in the shop after catching a cfl that was bright red and several others were bright red on one side. And the local electrical contractor that will be puttting mi wires up after the storm that took them down when it out the tree and wires on top of my truck has no idea why they were that bright red. To get enough light from hard to reach porciln socket outside I had a Y put in with 2 100 equivilent daylight led bulbs. One burnt out at less than 8 hours of use. That is where I found out the soft white do not put out as much ligh as is with those 2 bulbs within 6" of each other the soft white looks like only a 60 compaired to the daylight that looks like the 100 that they are both supposed to be. And as far as lasting I don't think they will last any longer than the incandesant bulbs. Just pay attention to the stop-tail lights of the vehicals ahead of you and no longer than they have been out for that you will see on a lot of the lights 1 or 2 of the individuall LEDS are out.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
