Any inward opening injector will have little return fuel when working right. Rotary pumps have more return to help cool and lube the pump internal cam ring and rollers. There's one more thing that should be checked. If NAPA/WIX filters are used MAKE SURE the filter top outer groove DOES NOT have an O ring in it. That's the filter inlet, I've seen several times where filters have been changed and an extra O ring has been put in that groove by mistake, either shutting off completely or severely restricting fuel flow. Top of filter is sealed by the base groove O ring. Had a Ford TW 35 on the dyno just this spring, owner drove it five miles. Pulled OK on the dyno about ten seconds, then lost power, and died. Asked if he replaced the filters, yup. Did you put the O rings where they belong? Found out there was NO base O ring, but one in the filter groove. Told him he's lucky it even made it here. Power came back just fine when the filters were installed correctly..
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
