Posted by keith molden on July 15, 2019 at 04:28:40 from (209.33.116.149):
My M6060 acts like it's governor quits working and the rpm drop down after a little while when doing any work with it. I've changed the fuel filter and drained all the fuel out of the tank (everything was clean and no dirt in the fuel at all. We took the fuel line off and blew through it with air several times. It has been regenned when the light came on. It only has 270 hours on it, but we drained the tran-hydraulic oil and replaced it just in case. No dirt and no burnt smell there either. this tractor has never been worked hard since I bought it new in 2017, the hardest work it's ever done is mowing with a drum mower and baling with a 4x4 baler. yesterday we had to put the Massey 255 on the baler after baling 9 bales with the Kubota (rpsm went down to around the 350 area). Let it set till we brought the baler home and went back after it. ( sat for a little over an hour. Went back and loaded 15 bales with it and roaded it home (about 41/2 miles) before we got home the top speed was 15 mph. Sitting still in neutral it will rev up but once any load at all is applied the rpms drop down gradually. Anybody got any ideas before I call the dealer and take it to them to fix. Keith
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
