Posted by Bret4207 on November 14, 2019 at 13:10:07 from (207.42.20.149):
In Reply to: Honest news ?? posted by Al Baker(pumpman) on November 14, 2019 at 06:43:00:
It's pretty tough these days. I read the headlines (online) and I look into the ones that seem too good or bad to be true. Usually I'm right when something sounds fishy in either direction. I also tend to look to a couple of conservative type radio hosts and see if they have some extra background info. Often there's a lot more to the story than the main stream news ever lets out.
PBS? Seriously? Same for BBC.
I stopped trusting the news about the 5th time I had a criminal case that was newsworthy and I'd spell the whole thing out and then see my case reported with facts omitted, apparently to tilt the story, or added (made up near as I could tell) to tilt it the way they wanted! Newsies are in business to sell information. Get used to it.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
