Posted by Bob Bancroft on February 06, 2020 at 16:27:57 from (174.32.104.86):
In Reply to: Gleaner combine help posted by crookedcreekjerseys on February 06, 2020 at 12:30:05:
Yes the 330 was available for the F/F2. But it shouldn't have been, as even with 18.4 tires, you can't hardly fit the combine between the unpicked rows.
The black, A series headers were made to fit multiple model combines. BUT, the "attaching", or finishing bundle sent with a new header, was particular to combine model. There might be filler sheets. Drives/jackshafts/sprockets, etc. would be different. I think the biggest challenge in putting a header on a K2 would be getting the drive from the narrow K2 throat to the header. I can't remember how that was accomplished. The manuals were pretty good about laying out all the pieces and parts in attaching bundles. If you could get a hold of a manual, it might be instructive.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
