Posted by Ron Muhlenkamp on November 27, 2021 at 08:30:02 from (24.144.186.247):
In Reply to: New Ford is running posted by grandpa Love on November 26, 2021 at 19:43:49:
Two parts to the problem One is whether your pump is working which others have addressed If so your lift arms will work When your lift arm work normally, the loader will still not lift unless your have or separate valve or you limit the range of the lift arms When DAd bot a loader for our NAA, they put a metal strap around each rear axle attached to piece limiting the lift arm to just above horizontal When you raised the control, the fluid went to the least resistance If the horizontal drawbar was empty, there drawbar came up to the limit before the loader came up if the drawbar was loaded, say a full spreader, the loader would go up to full height before the drawbar lifted the spreader tongue I should note the loader cylinders were single acting Hope this helps Ron
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
