The only way EVs become truly practical is with standardized battery packs and battery swap stations. Sure you can overnight charge your EV at home, but any travel you need to pull into the station and have the robotic system remove your depleted batteries from under the vehicle and replace them with fully charged ones. In and out in under 10 min just like a conventional liquid fueling.
This also eliminates the headaches of battery replacement / life as well since that is absorbed into the overall system. This is a very well established principle, it's what we have been doing with our welding gas cylinders for decades. We don't deal with 10yr hydrotest or waiting for a fill, we just drop off our (owned) cylinder and pickup a full one. We own a cylinder, just not a specific one, and we can readily do the exchange at different dealers as well without hassles.
This system does exist for EVs, China is pushing it a bit, but it needs to be fully standardized and widespread. Same battery packs for all vehicles, just different numbers i.e. 1 pack for a small car, 2 for a larger, 3 for a pickup, 6 for a semi, etc.
As for the power grid, distributed generation is the key there, don't try to transmit the power too far, generate locally. Solar PV on all rooftops, wind farms where viable, hydro / tidal where viable and the key - micro-nukes to fill in all the gaps. All green and all relatively locally generated to power the charging in the local area.
It will take time to get to that point, but that is where we need to end up if we want to go "green". The problem of course is the lack of clear leadership with a realistic vision of where we need to end up and the rational steps to get there, not pie-in-the-sky dreams and arbitrary and unrealistic dates.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.