Some miscellaneous thoughts: - Some guys complain because cause they only got 75 years out of a set of factory rims due to calcium.
- Rim maintenance is like oil changes - a pay me now or pay me MORE later deal.
- A tractor without added ballast can NOT put its full horsepower to the ground. If you are just going to fart around and use it for parades no ballast is okay. If you plan to actually do some usefull work with it you need added weight.
- A properly ballasted tractor is a more stable platform. It will not tip or roll as easily as an unballasted tractor will.
- If you take care of those rims now you will get many more years of good service out of them. Flats not withstanding.
- It is not that big of a job to repair a set of rims. Get them sand blasted, repair any rust through - even if the patches aren't that pretty - then brush on a coat of rustoleum primer and a couple coats of paint. That will make them last for many more years.
- Calcium Chloride is still the best bang for your buck when it comes to adding weight.
- By the way, those 3 cylinder Ford 4000s are outstanding old tractors.
- Here's one of a pair of rims from my own Ford 4000. I did as I suggested above. Then Of Course I put the calcium back in.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.