You still didn't answer if these indents are on the bottom sides of the rails. Maybe you looked, and just didn't put it in words here.
If one and the same rail was made for both sides, then the opposite rail would have an identical indent to the bottom side. Looks like the indents are in different locations at the top from one side to the other in photos. But do they have the indents on the bottom that would match the other sides top?? Of course this wouldn't matter if there was a right and a left side of these made.
But if there wasn't a left and right side of these made, and these indents are the only thing that makes them left or right, then this would further substantiate your theory. That they ARE there for a reason.
Barnyard makes a good point about the M's having the same engine (other than being Super) and near identical frame rails since 39. Why no identions until 53 super W6? If for carb and oil filter drainage, they would of already known this from running frame rails on the preluding M's with same set up to the frame rails.
The point about the diesels is a good point also. Maybe a connection to them, and yours had an engine swap at some point.
Have you seen other 53 gasers with these frame rails?? Or just yours? I don't know why I just asked that, because I'm under the impression that you have. And I'm not doubting you.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
