|
Tractor Talk Discussion Board |
ford 801 powermaster failure
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy Kippenhan on August 21, 2002 at 14:36:15 from (63.210.78.183):
My 801 will start and run normally, when cold, then quit after about 5 minutes. It just slows down and dies as if it had run out of gas, or the oil bath air filter badly needed cleaning, or it had lost compression, or ....? It will start again, but then will only run a few seconds, when hot. I changed the spark plugs, no effect. Cleaned the air filter, no effect. A small crack in the intake manifold which has been there for years MAY have recently gotten a little bigger, so I JB Welded it again, that will set up by tomorrow. Anyone have a clue? I need this thing to run. thanks so much Andy
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
