Tractor Talk Discussion Board |
Re: 3-pt What's the best way? Any tricks?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RobertTX on October 21, 2002 at 13:17:16 from (64.154.26.248):
In Reply to: 3-pt What's the best way? Any tricks? posted by Farmall Paul on October 21, 2002 at 12:49:15:
I read some of the how to articles and found them to be not very helpful. I came up with this method, and now can hook up any implement I have in just a few minutes without hurting myself. Back the tractor up to the implement with the arms raised. As you get near the implement, lower the arms so they rest on top of the pins on the implement that they will hook to. You do not need to be lined up perfect, just so the arms can rest on the pins. SHUT OFF THE TRACTOR !! This is for safety, not just for this procedure. Get down after shutting off. Hook up PTO drive shaft if needed for this implement. Next install the top link. You will need to have a functional top link, I keep antisieze on the threads on mine. After the top link is installed, look at the alignment of the pins with the balls in the arms. Extend or retract the top link to cause the implement to line up with the hole in one ball. When it looks centered, swing the arm off the pin and push the ball end onto the pin. Minor adjustments with the top link may be necessary. Clip this arm onto the pin and repeat with the other arm. The key is to use the top link instead of your back, foot, skull, or whatever to move the implement. If you have the threads lubricated, it works great. I can hook up my mower faster than it took me to write this, and I don't limp when I am finished. Final step is to check everything to be sure you are ready to go. Look at all pins and clips, pay special attention to the PTO driveshaft. Check sway bars or chains if your tractor has them. Crank it up and tractor away!
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|