|
Tractor Talk Discussion Board |
Re: International 3514 -- hydrostatic drive
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob/Ont on December 16, 2002 at 09:02:42 from (172.140.94.162):
In Reply to: International 3514 -- hydrostatic drive posted by Robert on December 16, 2002 at 08:50:26:
The worst case scenario Robert, would be an over haul of the drive pump and motor. I have never seen the inside of that tractor but have seen a lot of Hystat drives. If the drive pump and motor are external, not inside a case, they should have a CASE DRAIN line on them to return leakage to the hyd tank. Measuring this leakage will tell if the pump or motor is the cause of low drive pressure. However you may luck out and find it's only a relief valve. Good luck with it.
Later Bob
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
