Tractor Talk Discussion Board |
Re: Starting old European diesels
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by GlennT on December 22, 2002 at 21:20:37 from (168.215.176.239):
In Reply to: Starting old European diesels posted by GlennT on December 22, 2002 at 06:01:55:
Thank you for the information. It was helpful. Apparently old diesels were started in a variety of ways: with a cartridge containing gun powder, with a blow torch, with a wad of cotton soaked in a flamable solution, with compressed air, and with a spark plug using gasoline and then switching over to diesel fuel. I could be mistaken, but I believe that an engine using the last technique is called a "semi diesel" because its compression is relatively low. By the way, when the Landini's RPMs are dropped to a very slow idle, you can reverse the direction that the engine turns by advancing the throttle at just the right instant. I had heard of this being done and in fact have read of antique tractors that used this technique to reverse their direction, there being no reverse gear in their transmissions. Really interesting stuff and fascinating to watch! Thanks again for the information.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|