Tractor Talk Discussion Board |
Re: Drawbar ball hitch
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Slowpoke on June 04, 2004 at 01:29:41 from (4.246.18.198):
In Reply to: Drawbar ball hitch posted by CityBoy on June 02, 2004 at 20:08:16:
You can buy a small device to keep the drawbar from spinning for about $25. Try any tractor dealer or farm supply. I had one in the early '90s for a Ford 9n, but it was stolen. You can make something like it by starting with a 1/4 or 5/16 thick x 2-1/2 wide x 5" long piece of steel. Set the drawbar at the height it will be used for towing. Then about 1/2" from the end of the steel cut an oblong hole that will slip over the drawbar so the piece will lay up against the lower lift arm. Drill two holes at the oposite end to match a 'U' bolt. Put the plate on the drawbar and the 'U' bolt over the lift arm and thru the holes in the plate. Or you can weld two tabs on the end with matching holes on the outer ends to take a pin outside the arm instead of the 'U' bolt. Size the plate to fit your application.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|