Tractor Talk Discussion Board |
Re: Water Well Problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CBBC on December 19, 2005 at 22:41:31 from (24.64.223.203):
In Reply to: Water Well Problems posted by john in la on December 19, 2005 at 18:05:30:
Hi John, Call a pump guy or an electrition if you don't know what you are doing!!! My guess is the pressure switch. Do you hear it click on when the water starts to run again. Give it a tap gently and it may start. The pipe fittings to the switch might be plugged or it might be the switch itself.
If the foot valve went, the pump would be cycling on and off a lot when no fauctes are running(if the presure switch is not buggered). Last spring I put in an inline anti-back flow valve because the foot valve jamed open. Then I replaced the pressure switch. A week later the motor gave up. I pulled 100' of 2" steal pipe out and then it slipped (the installers put no rope on the pump) I snagged the electrical wires and fished it up on a snatch block, with 5 guys we pulled the remaining 100' of pipe out, pump was squashed from drop. Went to Home Depot at 6pm. Bought a new pump with starter, 200' plastic pipe drop new wire and other assorted goodies. By 1:30 am we had water again. Not a good day. Did I mention I had a six month old and a wife used to being on city water. Good luck, hopefully you don't need to pull the pump in the winter. Grant
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|