Tractor Talk Discussion Board |
Re: Placement of Ballast Resistor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Thomas Donahy on January 15, 2006 at 11:40:26 from (64.149.37.47):
In Reply to: Re: Placement of Ballast Resistor posted by KEB on January 15, 2006 at 08:45:16:
Dear electrical wizards, Thank you for your responses, but I am still confused. The question is more than academic as I am presenting a workshop on point type ignition at the Gathering of the Green conference in March. Perhaps I can be more specific in my questions. 1. How does the secondary circuit return to the coil? Does it arc through condensor while the plug is firing? The voltage in the secondary is certainly dc as the spark line or I should say firing line is relatively flat on the scope and doesn't start to oscillate and become ac until the coil can no longer jump the plug gap. The circuit can't be completed through the points as they are open when the plug is firing. Does the secondary complete its path from the block, through the ground wire, through the battery,the key switch, and back to the junction inside the coil? Either way I don't see how the placement of an additional two ohms could possibly affect the secondary when you are dealing with up to 20,000 volts.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|