Tractor Talk Discussion Board |
Help any mechanical engineers in the group..
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BobReeves on February 07, 2006 at 10:12:16 from (70.184.21.197):
Say you have a hydraulic cylinder with a 4 inch stroke and you need to move 6 pieces of steel ( 1/2 x 2 x 12 spaced about a foot apart ) straight up (vertical) 5 inches. It would also be better (easier to mount) if the cylinder was laying flat instead of vertical. What combination of levers, cams etc. would one need to make in order to accomplish the objective. Have been thinking about rotating a long piece of pipe with levers off the pipe to raise the steel shanks but I get too much horizontal movement where the lever would pin to the shank to make it work. Any ideas?
Replies:
Home
| Forums
Today's Featured Article -
A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|