Tractor Talk Discussion Board |
Re: When to change the oil?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by farmalls all the way! on March 15, 2006 at 13:25:22 from (64.91.160.154):
In Reply to: When to change the oil? posted by DavidA on March 15, 2006 at 10:16:58:
I, like many others on this board, have way more tractors than I need and don't farm full time. I currently got 4 running tractors (and 2 that don't) and don't have a single cow on the place. About all the use they see is what little I do while hobby farming. I raise and sell a couple acres of hay and do maple sugaring. I also till a couple gardens in the spring and do some brush hogging in the summer, but, they still don't see all that much use. I usually change the oil every year spring before they get used. I like to change it in the spring because they have all sat the entire winter, and I'm sure condensation has gotten in the oil. My Farmall H had gotten condensation in the gas over setting since October, and when I went to use it this spring, I used it for a day, then when I started it up the next, it didn't run too long before it quit, upon inspection, I found the problem to be the settling bowl for the gas had filled full of water and had froze so no gas could get through, I took it off and emptyied it out, and no more problems, but it was surprising how much condensation had gotten in there, engine oil I'd imagine would be the same way. Yeah oil and filters cost right up there, but it's never been a cheap hobby and a destroyed engine is even more costly!.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|