Tractor Talk Discussion Board |
Re: How much weight will it hold
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by old on October 23, 2006 at 19:54:00 from (4.244.6.247):
In Reply to: Re: How much weight will it hold posted by Janicholson on October 23, 2006 at 19:48:03:
If I had the sheet metal I would put it under the foam but since I don't I can't. Also the way this building is and heat goes up if it did start to burn the smoke etc would go out all the holes in the roof metal and give me/us time to walk away from it. The faom would also be up abut 10 foot off the gravel floor if not higher. Right now I have maybe $200 in this building and its about a 30X40 building most of it is built from scrap stuff form over the years. The older part of it was built new from oak lumber by my dad and back when it was built I think he said he apyed something like $200 for all the lumber
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|