Tractor Talk Discussion Board |
Re: Haying Picture
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NEsota on December 15, 2006 at 13:15:47 from (64.131.55.170):
In Reply to: Haying Picture posted by MRN on December 14, 2006 at 15:39:21:
In summer 1955 Uncle Albert, age 57 and I age 15 would regularly bale and load 1000 bales a day with a NH baler, which must have been a predecessor to the one in photo. We did not have a thingie to kick the bales in the air but the shoot was set so that they came out of the baler two bales high and we went up from there. Loads always had some bales in the middle of rack that were 7 high. Loads had 113-115 bales and we blew out a lot of old car tires. We traded off on each load driving tractor and loading. This physical stuff made football easy in the fall.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|