Posted by jdemaris on January 05, 2008 at 08:10:38 from (67.142.130.15):
In Reply to: diesel cold starting posted by KEH on January 05, 2008 at 06:58:32:
Many of the old diesels with electric starters (instead of pony motors) used hand-pumped fuel primers along with glow plugs - and they worked pretty good when setup properly. Deere had them on the 1010s and 2010s and they would start pretty good when all was right. My Allis Chalmers HD6 with a Buda diesel has the hand fuel primer as well as an ether injector.
Many later Deeres with direct-injection relied on automatic ether injection and hyraulic pump destrokers.
Cold starting was a big issue at our Deere dealership because we had many logger customers with dozers and skidders sitting out in the woods - with no electricity and temps down to minus 35 F. Many loggers would park their 350 or 450 dozers in creeks every night in water 2 feet deep. That kept the undercarriage from freezing solid and the engine a little warmer than the air - but made for some awful road-calls. Also no fun breaking the ice on top every morning to get the dozer out.
The reality was - in those cold temps - out in the woods - nothing started without help. Some of our customers installed propane or diesel fired block heaters and some used portable generators to run electric block heater.
One neat trick was using quick plug-in couplers to the cooling system. Many guys with pickup trucks would pull up to the jobsite - keep the truck engine running - and plug the truck cooling system into the one on the dozer or skidder. Then, the truck acted like a big pony motor and sent warm coolant over and got the engine warm enough to start.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
