in-too-deep said: (quoted from post at 19:26:11 02/04/08) Been wanting to ask this for sometime now. I've got a Miller Thinderbolt 220V AC stick welder at work. It's harder than heck to strike up an arc. Once it gets rollin' I can weld all day, but if I stop, and instantly try to start again it just won't catch. I use 7018's and 6013's, and I even tried drying them real good in an oven and it didn't improve. Any ideas?
Run the Miller on the 'low' tap whenever you can as that gives you less amps but more OCV (OpenCircuitVoltage) which starts better with most rods.
If you can get your hands on a hi-frequency unit you'll be able to run lo-hy (7018) and such like you were using DC; all rod types start dead easy with the hi-frequency running over the welder's AC. I've seen the older MID-STATES units on eBay for $50-100; I've got one and they are a good unit. Once you get hi freq-ed you're pretty close to a TIG setup; all the extras you need for that is a bottle of argon, flowmeter and tig torch once you get the hi frequency unit. Here's my setup (the bottle and TIG torch aren't visible in the photo):
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
